Boost sensor port on intake?

[Digger]

Where does everyone connect their boost sensor to? The only port I found on the intake is for the MAP sensor.

[RePowerToy]

I have not put one in. Because the Murphy broadcasts boost info. Have never needed to but if you want to run on I would say drill and tap the intake elbow? Or better yet one of your intercooler pipes.

[Sanders]

I second RepowerToy - I'm using the CAN signal for boost on my Murphy PV101

[Digger]

Roger guys. Wanted to make sure I wasn't missing anything. There is an open port on the cold side of the CAC I can use for my gauge. I will keep the CAN broadcast in mind, that is good to know. Thanks!

[Aggie Jeeper]

how are you seeing boost on Murphy? I have not seen option for that?